I have an Elevation 3/4 Size Acoustic Guitar, as a normal size one is too big for me right now as I'm only 14 and it's my first guitar and money is tight. When I tighten the strings to tune it, the low E string makes a pop sound and goes really loose. I looked at the place where the end of the string sits at the top and saw when it makes the pop sound the tube thing that holds the string jerks back to its original place. I'm just wondering what is doing this and how to fix it? Any help is really appreciated.
The screw at the end of the tuning machine can back out and be loose, causing some free play between the gear and the housing, causing slipping when tension is applied.
Try loosening the string until there is no tension on the tuner and then gently tightening the screw at the gear on the peg that is slipping. You may have to wiggle or pull in the post towards the gear to get it to seat.
How To Restring A Guitar In 6 Easy Steps
If the screw does move, continue to tighten it until it seats and then add a little more tightness. Don't over-tighten the screw, if it backs out with use you can tighten it a little more next time.
Sometimes you have to remove the screw and gear and pull the post in towards the tuner before replacing the gear and screw to get it to seat properly.
If the screw is not loose and there is no free play of the plastic string post then it is possible that the tuning machine is faulty. In some cases I have fixed a gear slipping problem by exchanging the gears between two different posts.
Got A Ukulele
This video looks like a good guide. Please try installing the strings according to the instructions here and update the question if you still have trouble.
If this does not work for you, it's possible that you have a problem with the actual tuning machine, which is plausible based on this from your question:
In that case, it would be worth taking the guitar to a local shop and asking for advice. Most guitar shops are willing to look at issues like this and give good advice.
Guitar Maintenance: How To Fix Loose Tuners
EDIT: Note that the handy string winder is a convenience only - you don't need the electrical one, but the ordinary hand-powered one can be a help.This article was co-authored by Carlos Alonzo Rivera, MA and by staff writer, Jennifer Mueller, JD. Carlos Alonzo Rivera is a guitarist, composer, and educator based in San Francisco, California. He holds a Bachelor of Arts degree in Music from California State University, Chico, as well as a Master of Music degree in Classical Guitar Performance from the San Francisco Conservatory of Music. Carlos specializes in the following genres: classical, jazz. rock, metal and blues.
It happens to even the greatest guitarists. You're playing a gig, or maybe out jamming with friends, and a string snaps. You don't have an extra set of strings with you, and you aren't in a place where you can easily buy more. In some situations, you may be able to fix the broken string so you can keep playing. While this temporary fix can save you some time (and money), you still want to replace the broken string as soon as possible. The best (and sometimes only) way to truly fix a broken guitar string is to replace it.
This article was co-authored by Carlos Alonzo Rivera, MA and by staff writer, Jennifer Mueller, JD. Carlos Alonzo Rivera is a guitarist, composer, and educator based in San Francisco, California. He holds a Bachelor of Arts degree in Music from California State University, Chico, as well as a Master of Music degree in Classical Guitar Performance from the San Francisco Conservatory of Music. Carlos specializes in the following genres: classical, jazz. rock, metal and blues. This article has been viewed 157, 330 times.
What Is This Thing That The Strings Go Under? Does It Cause The High E String To Break When Tuning Down?
To fix a snapped guitar string, pull out the corresponding bridge pin at the bottom of your guitar to free the broken string. Next, unwind the broken string and twist it back through the ball end 3-4 times, so it stays attached. Once it's secured, unwind the string from the tuning post at the top of your guitar for more slack and put the broken end back into the peg hole. Then, pull the string back up to tune it to the right note. Alternatively, if you need to replace a string, remove both ends of the broken string, then slip the ball end of the new string into the peg hole. From here, you should pull the end of the string through the tuning post and bend it 90 degrees, so you can wind it up. For more tips, like how to prevent your strings from snapping, keep reading!
EDIT: Note that the handy string winder is a convenience only - you don't need the electrical one, but the ordinary hand-powered one can be a help.This article was co-authored by Carlos Alonzo Rivera, MA and by staff writer, Jennifer Mueller, JD. Carlos Alonzo Rivera is a guitarist, composer, and educator based in San Francisco, California. He holds a Bachelor of Arts degree in Music from California State University, Chico, as well as a Master of Music degree in Classical Guitar Performance from the San Francisco Conservatory of Music. Carlos specializes in the following genres: classical, jazz. rock, metal and blues.
It happens to even the greatest guitarists. You're playing a gig, or maybe out jamming with friends, and a string snaps. You don't have an extra set of strings with you, and you aren't in a place where you can easily buy more. In some situations, you may be able to fix the broken string so you can keep playing. While this temporary fix can save you some time (and money), you still want to replace the broken string as soon as possible. The best (and sometimes only) way to truly fix a broken guitar string is to replace it.
This article was co-authored by Carlos Alonzo Rivera, MA and by staff writer, Jennifer Mueller, JD. Carlos Alonzo Rivera is a guitarist, composer, and educator based in San Francisco, California. He holds a Bachelor of Arts degree in Music from California State University, Chico, as well as a Master of Music degree in Classical Guitar Performance from the San Francisco Conservatory of Music. Carlos specializes in the following genres: classical, jazz. rock, metal and blues. This article has been viewed 157, 330 times.
What Is This Thing That The Strings Go Under? Does It Cause The High E String To Break When Tuning Down?
To fix a snapped guitar string, pull out the corresponding bridge pin at the bottom of your guitar to free the broken string. Next, unwind the broken string and twist it back through the ball end 3-4 times, so it stays attached. Once it's secured, unwind the string from the tuning post at the top of your guitar for more slack and put the broken end back into the peg hole. Then, pull the string back up to tune it to the right note. Alternatively, if you need to replace a string, remove both ends of the broken string, then slip the ball end of the new string into the peg hole. From here, you should pull the end of the string through the tuning post and bend it 90 degrees, so you can wind it up. For more tips, like how to prevent your strings from snapping, keep reading!
0 Response to "Guitar String Keeps Loosening"
Posting Komentar